用于嵌入系统的超声电机驱动设计

为了在嵌入式控制系统中充分利用超声电机特有功能,对超声电机的驱动原理进行了研究,在分析了超声电机的驱动控制原理的基础上,提出了一种基于单片机控制超声电机的软硬件控制实现方法。利用单片机输出数字量作为控制信号,通过串行输入并行输出芯片扩展后,输出到超声电机驱动器,实现超声电机启动/停止/正反转的功能;通过扩展单片机数模转换,将单片机控制超声电机速度的数字信号转换为电压信号,实现超声电机的速度控制功能;利用运行脉冲宽度控制实现超声电机的位置控制功能,并将光电编码器实现超声电机的反馈,最后通过试验验证了单片机系统实现超声电机驱动设计。     

An investigation on the microstructural and electrical properties of La0.85DxSr0.15–xGa0.8Mg0.2O2.825 (D = Ba and Ca) electrolytes in solid oxide fuel cells

La_0.85D_xSr_0.15–xGa_0.8Mg_0.2O_2.825 (D = Ba and Ca, x?=?0, 0.01, 0.03, 0.05, and 0.07) electrolytes were synthesized using a solid-state reaction method, calcined at 1400?°C for 5?h, and sintered at 1400?°C for 5?h. The microstructures, electrical properties, and cell performances of the electrolytes and fuel cells were analyzed by X-ray diffraction, scanning electron microscopy, impedance analysis, and electrochemical analysis. La_0.85Ba_xSr_0.15–xGa_0.8Mg_0.2O_2.825 (LBSGM) and La_0.85Ca_xSr_0.15–xGa_0.8Mg_0.2O_2.825 (LCSGM) exhibit a dense structure and a cubic perovskite phase. Further, they contain small amounts of a secondary phase. The lattice constants of LBSGM and LCSGM are 0.3913–0.3914?nm and 0.3906–0.3909?nm, respectively. The average grain size of the sample increases with increasing Ba²⁺ or Ca²⁺ content. The conductivity of LCSGM (0.197–0.174?S/cm) is usually higher than that of LBSGM (0.181–0.162?S/cm) at 800?°C. The cells with La_0.85Sr_0.15Ga_0.8Mg_0.2O_2.825 and La_0.85Ca_0.03Sr_0.12Ga_0.8Mg_0.2O_2.825 electrolytes exhibit high open-circuit voltages and maximum power densities of 0.96?V and 542?mW/cm² and 0.94?V and 567?mW/cm², respectively, at 800?°C.     

Temperature of post‐flashover compartment fires—Calculations and validation

This paper describes and validates by comparisons with tests a one‐zone model for computing temperature of fully developed compartment fires. Like other similar models, the model is based on an analysis of the energy and mass balance assuming combustion being limited by the availability of oxygen, ie, a ventilation‐controlled compartment fire. However, the mathematical solution techniques in this model have been altered. To this end, a maximum fire temperature has been defined depending on combustion efficiency and opening heights only. This temperature together with well‐defined fire compartment parameters was then used as a fictitious thermal boundary condition of the surrounding structure. The temperature of that structure could then be calculated with various numerical and analytical methods as a matter of choice, and the fire temperature could be identified as a weighted average between the maximum fire temperature and the calculated surface temperature of the surrounding structure as a function of time. It is demonstrated that the model can be used to predict fire temperatures in compartments with boundaries of semi‐infinitely thick structures as well as with boundaries of insulated and noninsulated steel sheets where the entire heat capacity of the surrounding structure is assumed to be concentrated to the steel core. With these assumptions, fire temperatures could be calculated with spreadsheet calculation methods. For more advanced problems, a general finite element solid temperature calculation code was used to calculate the temperature in the boundary structure. With this code, it is possible to analyze surrounding structures of various kinds, for example, structures comprising several materials with properties varying with temperature as well as voids. The validation experiments were accurately defined and surveyed. In all the tests, a propane diffusion burner was used as the only fire source. Temperatures were measured with thermocouples and plate thermometers at several positions.     

Study on the relationship between the particle size distribution and the effectiveness of the K‐powder fire extinguishing agent

The relationship between the particle size distribution and the extinguishing effectiveness of the new K‐powder fire extinguishing agent has been studied experimentally, to explore the reason of the great extinguishing efficiency exhibited by the new K‐powder fire extinguishing agent on Class B fire (liquid fuel fire). The results of the experiment showed that the extinguishing effectiveness increased along with the decrease of the particle size distribution. In addition, a sharp discontinuity appeared around the limiting size, about 40 μm. The powder with the particle size below 40 μm exhibited highly effective extinguishing with the minimum effective extinguishing concentration C_xr = 23 g·m^?3, while the powder with the particle size above 40 μm exhibited little fire extinguishing efficiency. Compared with other fire extinguishing agents produced by different substances, the new K‐powder fire extinguishing has the bigger limiting size. That means, in the same particle size distribution, the new K‐powder fire extinguishing agent contains more highly effective powder than others contain, and is more effective.     

New approaches to determine the interface height of fire smoke based on a three-layer zone model and its verification in large confined space

Large confined space has high incidence of fires, which seriously threatens the safety of people working there. Understanding the distribution of smoke in such large space is critical to fire development prediction and smoke control. Three improved methods for the stratification interface prediction of fire smoke are developed, including of improved intra-variance, integral ratio and N-percentage methods. In these methods, the interface height is determined by the vertical temperature distribution based on a three-layer smoke zone model, which is an improvement of a two-layer zone model. Thereafter, the three improved methods are applied to several typical fire cases simulated CFD to predict the smoke interface, and their applicability and reliability are verified by comparison of the smoke stratification results with the filed simulation results. Results show that the three improved methods can effectively determine the location of the three-layer zone model's interface, and they have the ability to predict smoke interface for fires with different fire source types and ventilation conditions.     

Tangeretin Ameliorates Glucose-Induced Podocyte Injury through Blocking Epithelial to Mesenchymal Transition Caused by Oxidative Stress and Hypoxia

Podocyte injury inevitably results in leakage of proteins from the glomerular filter and is vital in the pathogenesis of diabetic nephropathy (DN). The underlying mechanisms of podocyte injury facilitate finding of new therapeutic targets for DN treatment and prevention. Tangeretin is an O-polymethoxylated flavone present in citrus peels with anti-inflammatory and antioxidant properties. This study investigated the renoprotective effects of tangeretin on epithelial-to-mesenchymal transition-mediated podocyte injury and fibrosis through oxidative stress and hypoxia caused by hyperglycemia. Mouse podocytes were incubated in media containing 33 mM glucose in the absence and presence of 1–20 μM tangeretin for up to 6 days. The in vivo animal model employed db/db mice orally administrated with 10 mg/kg tangeretin for 8 weeks. Non-toxic tangeretin inhibited glucose-induced expression of the mesenchymal markers of N-cadherin and α-smooth muscle actin in podocytes. However, the reduced induction of the epithelial markers of E-cadherin and P-cadherin was restored by tangeretin in diabetic podocytes. Further, tangeretin enhanced the expression of the podocyte slit diaphragm proteins of nephrin and podocin down-regulated by glucose stimulation. The transmission electron microscopic images revealed that foot process effacement and loss of podocytes occurred in diabetic mouse glomeruli. However, oral administration of 10 mg/kg tangeretin reduced urine albumin excretion and improved foot process effacement of diabetic podocytes through inhibiting loss of slit junction and adherenes junction proteins. Glucose enhanced ROS production and HIF-1α induction in podocytes, leading to induction of oxidative stress and hypoxia. Similarly, in diabetic glomeruli reactive oxygen species (ROS) production and HIF-1α induction were observed. Furthermore, hypoxia-evoking cobalt chloride induced epithelial-to-mesenchymal transition (EMT) process and loss of slit diaphragm proteins and junction proteins in podocytes, which was inhibited by treating submicromolar tangeretin. Collectively, these results demonstrate that tangeretin inhibited podocyte injury and fibrosis through blocking podocyte EMT caused by glucose-induced oxidative stress and hypoxia.     

Effects of ethylene-octene copolymer (POE) on the brittle to ductile transition of high-density polyethylene/POE blends

Three kinds of ethylene-octene copolymers (POE) were melt-blended with high-density polyethylene (PE-HD) in different proportions. Detailed characterizations were conducted to analyze their structural differences of POE and its effects in toughening PE-HD. The higher molecular weight POE can improve the toughness of PE-HD. 60:40 PE-HD/POE is elongated to break up to 700% while impact strength is 84.7 kJ/m² at −30°C, which is 21-fold of PE-HD. In the brittle to ductile transition (BDT) during impact, the fracture mechanism changes from the crazing mode to the shear yield-plastic deformation mode. The BDT temperature decreases as the POE molecular weight and its content increase. The interface strength in tension is estimated to access their effects. The Boltzmann-type models were successfully extended to describe the typical S-shaped curves in BDT of notched impact strength vs POE content or temperature. The supplementary decay model is suggested for the attenuation in toughening. Transition map in impact is proposed to select the use range of composition (c ) and temperature (T ) for high toughness. The curves are converted into 3D graph of T -c -impact strength for illustrating their coupling-separate effects, and further into the contour map of impact strength in T -c space for finding their partial equivalence.     

公民新闻与权力变移

公民新闻的诞生源于信息网络技术的推动,同时也得力于媒介接近权的付诸实践。结合国内外学者的网络社会学主要研究成果,本文着重探索和分析了媒介权力变移所呈现出来的知识化、扁平化和分散化的趋向,并分析研究了现今阶段公民新闻在媒介权力变移过程的所面临的问题。     

Designing e-Coordinator for improved teams collaboration in graduation projects

The work presented in this paper describes the design for Graduation Project eCoordination System in our department. The proposed eCoordinator provides effective team–team, supervisor–team and coordinator–supervisors–teams collaboration. eCoordinator is an attribute based framework that serves evolving an object oriented software system into agent oriented software system. Nowadays, agent-oriented software development technologies have evolved rapidly; it is emerging as a new paradigm for constructing intelligent more autonomous software systems. Therefore, several methodologies are available and it is difficult to determine the most appropriate methodology for specific project within different domains. This is especially occurs when re-engineering current object oriented software system. The case study is going to be rebuilding a virtual graduation project coordinator in Information Technology Department at King Saud University.     

陕西煤灰纱出现的特征性规律与防治

煤灰纱严重影响纺织产品质量,同时也是难以解决的技术问题。文章分析了煤灰纱出现的特征性规律,试图找到防治煤灰纱的措施,从而找到切实可行的技术解决途径。